Hello all, I had to re-register...I was on the forum before w/ my 636, but I didn't log on for a long time due to deployments overseas combined with the sale of my bike. Good news though, I'm back in the saddle again. This time w/ a brand new 07 ZX10R Ebony limited. Pics to follow...Alright, I checked and didn't see any threads in regards to this; so, if it's repeat don't blast me just tell me where I can find it. 2007 ZX-10R bar ends seem to be a pain in the butt tolocate. I want an after market set heavier than the factory to lower the vibration in the throttle, which is making my hand go numb. Little help...anyone? [&o]

 

They might not make them yet for the new bike. try here www.kneedraggers.com they might have them.

or don't

 

The 06 and 07 are the same. I changed out the grips only on mine which helped. There are heavier bar ends out there, if I can find the site again.

 

Here is the link I was thinking of. http://www.twistedthrottle.com/trade...view/2068/439/

 

Only problem I see is that they dont make that specific one for 2001 + ZX10R.

 

2001? All I know is that my clip ons are 7/8" for the '90 7 and the '06 10r. I did see an end for the bars. Thread pitch is the end result.

 

Yea its weird, if you look at the bar end page it says they will not fit current model zx10R's, I was interested also actually. I have a bad wrist and it goes to sleep sometimes.[:-]

 

I have the same problem. I found that it is better when I use my knees more on the tank and take some of the weight off of my hand buy using my back and core muscles. But, yeah, grips and ends are in my future, too.

Thank for the site Dragone.

 

hahaha, was going to say something about your wrist. lmao, but will not.
But since I went with a 50 series rear, and using my legs more, the ride steers pretty darn good for the streets. The bars are only there for input, think of that and not just a handle.

 

Does the 05 - 07 the same?? If so I have a pair out of stainless steel.