Whats the use of this?
#1
Whats the use of this?
hey all! any of you guys know whats the use of part no.16126?
Thanks
Will this fit a klx250 2006?
http://www.ebay.com/itm/2009-09-KLX2...1WFPM-&vxp=mtr
Thanks
Will this fit a klx250 2006?
http://www.ebay.com/itm/2009-09-KLX2...1WFPM-&vxp=mtr
Last edited by kennysupermoto; 10-28-2015 at 04:50 PM.
#2
That's your air injection system, part of it. Most have removed it, and plugged the nipples where hoses went in 3 places. Front of cylinder, front of airbox, and top of front of carb at the intaked boot (between carb and cylinder. This system injects clean air into header pipe at exhaust port to help burn off unburned fuel in your exhaust. This makes excessive heat in your header pipe. Smog control more or less. Your header pipe will be cooler without it. There are threads here about it.
#3
That's your air injection system, part of it. Most have removed it, and plugged the nipples where hoses went in 3 places. Front of cylinder, front of airbox, and top of front of carb at the intaked boot (between carb and cylinder. This system injects clean air into header pipe at exhaust port to help burn off unburned fuel in your exhaust. This makes excessive heat in your header pipe. Smog control more or less. Your header pipe will be cooler without it. There are threads here about it.
#8
Don't buy that junk. If you need to re-install it to pass inspection I would suggest that you let the group know that you need it. I'm sure someone has it laying around...although mine went straight in the dumpster.
#10
How much of a difference would that make on an inspection? Over here new bikes get a 5 year exemption, then once a year after that. I'd like to remove it but might "carefully" remove it if I'll need to put it back.
Figure I can lean it out pretty good with my EJK before inspection. Might be enough.
Figure I can lean it out pretty good with my EJK before inspection. Might be enough.