Turn Signals
#1
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
I broke my rear turn signal lens. I am looking to replace the rear signals with something that is flush-mounted/low profile (less stuff hitting the brush). Does anyone have a set-up like this or know where to look?
#2
#3
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
I got these after my OEM flasher was dangling in Gorman CA. So far so good and I lay this thing down once a ride at the least
sorry I dont have a better close up they are the 601's.
https://www.wheelingcyclesupply.com/...ed-flashers/52
![Big Grin](https://www.kawasakiforums.com/forum/images/smilies/biggrin.gif)
https://www.wheelingcyclesupply.com/...ed-flashers/52
#5
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
I had the same issue with my '12. A simple tip-over broke the lens on the turn signal so I decided to find a better solution. This is what I came up with- BikeMaster Universal Flush Mount Marker Light Kit - BikeBandit.com
The bulb faces to the rear so they are quite bright when flashing. I also transferred the shorter rubber stalks from the rear signals to the front signals to tuck them in a bit more. After quite a few 'tumbles' the lamps have been holding up quite well.
The bulb faces to the rear so they are quite bright when flashing. I also transferred the shorter rubber stalks from the rear signals to the front signals to tuck them in a bit more. After quite a few 'tumbles' the lamps have been holding up quite well.
#7
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
K&S Universal Marker Lights - Small - Black/Amber on eBay!
I run these on my bike because of my fmf pipe, easy to install, just spliced old wiring off old directional harnesses, soldered new lights into the stock harness so that I could still use the stock connectors and not have to worry about having to splice wires or anything if I were to break one, just unplug.
I run these on my bike because of my fmf pipe, easy to install, just spliced old wiring off old directional harnesses, soldered new lights into the stock harness so that I could still use the stock connectors and not have to worry about having to splice wires or anything if I were to break one, just unplug.
![](https://sphotos-b.xx.fbcdn.net/hphotos-ash3/578146_10151318504645308_1925373233_n.jpg)
#8
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
I installed the flush mounted turn signals from Bike Bandit that GBAUTO used and also used the short stems on the front. They look good. I would love to show the pictures but I can' figure out how to post them.
#10
![Default](https://www.kawasakiforums.com/forum/images/icons/icon1.gif)
I got these after my OEM flasher was dangling in Gorman CA. So far so good and I lay this thing down once a ride at the least
sorry I dont have a better close up they are the 601's.
https://www.wheelingcyclesupply.com/...ed-flashers/52
![Big Grin](https://www.kawasakiforums.com/forum/images/smilies/biggrin.gif)
https://www.wheelingcyclesupply.com/...ed-flashers/52
how do you know what size. To order. Sorry I’m new and on my 4th set of back lights….. I fall a lot. Lol