[sm=closed.gif]Hi. I'm putting some B&B frame guards on my H7. The thing is, I've had to remove the side stand switch to get a snug fit. I've traced the cable to the loom connection and removed it, along with the switch itself. What I want to know is do I leave the 2 wires from the loom apart and SAFE them up with some cable shrink, or do I join them together (male & female bullet connection) and SAFE them up with some cable shrink? Anyone there done the mod.

Note; I'm not too worried about the loss of the safety element.

 

plug them into each other.

 

Thanks EMS. Can I use the [sm=closed.gif]smiley?

 

SURE....thats what i did.... i have only left it down a few times after taking off.... lol [8D]