Seat Concepts Cover/Foam Kit
#6
I installed one of these kits back in 2016 and have been very happy with it, much better than the stock. The only thing for me is that I would have preferred if the foam had been a little bit less firm, can't remember if there are any options there.
Don't remember the installation being difficult in any way, although having a helper stretching and holding the cover while you staple is probably necessary. Also, make sure you have a good quality staple gun with staples that are not too long (obviously).
Don't remember the installation being difficult in any way, although having a helper stretching and holding the cover while you staple is probably necessary. Also, make sure you have a good quality staple gun with staples that are not too long (obviously).
#7
Purchased and installed one back in 2010 on my 2010. Still a great seat to have while out exploring for hours at a time. Install was not difficult. Just make sure you have a good, I mean a good electric or pneumatic stapler. I watched a few youtube videos on the subject before tackling the project.
#8
Thanks for the reply's! Think I'll order one and try it out. May look for a stock pan to keep my original if needed. About the only thing I haven't done to it since buying new in 2006.
Thanks
D-
Thanks
D-
#9
I had an upholstery guy here in Vietnam so mine for about $5. He had a nail gun hooked up to an air compressor to make life easy. I'm sure there's how to videos on YouTube for this. He did remove a few nails to adjust it to perfection.