RockyMountainATV sends a bearing w/o protective oil, they say it's OK
#22
Dan, did you check the packing material carefully for anthrax or other biological hazards? I just know this whole episode can't go this smoothly.
#23
gassp!!! ack! ugh
Is that what you want T&C?? I keep forgetting to rub the brand spanking, almost new, shrouds I picked up, in your nose too.
Right side engine case is in the oven right now warming to 200 degrees. Bearings are in the freezer. In about ten minutes they will be dropping in.
Dan
#25
Vision getting blurryy.. ... ca n't t ype.............don't f e e l s o good . ...
gassp!!! ack! ugh
Is that what you want T&C?? I keep forgetting to rub the brand spanking, almost new, shrouds I picked up, in your nose too.
Right side engine case is in the oven right now warming to 200 degrees. Bearings are in the freezer. In about ten minutes they will be dropping in.
Dan
gassp!!! ack! ugh
Is that what you want T&C?? I keep forgetting to rub the brand spanking, almost new, shrouds I picked up, in your nose too.
Right side engine case is in the oven right now warming to 200 degrees. Bearings are in the freezer. In about ten minutes they will be dropping in.
Dan
#26
Right side bearings went in tonight with a few taps from the bearing driver.
Left side went in last weekend. Crank/main bearing and one of the others dropped in, the other two had to be tapped in with the bearing driver. Note the frosty crank. ( The bearing driver set is a loaner from the local Autozone store, you put down the cost of the tool ,$60 in this case, and then when you return it they refund the money. It's a really nice deal)
trans back in
test fit case together.
#29
Thats what should have happened the first time, remind me why you are doing a rebuild? I have to do mine when the bits arrive
Thread
Thread Starter
Forum
Replies
Last Post