new (to me) 2009 KLX250SF
#21
I watch people all the time here in Vegas not pull over for Emergency vehicles. If people aren't seeing or hearing them, I know I don't even register to them.
Always on defense I guess. I am changing my tune a bit about exhaust's. I may start looking for something.
Always on defense I guess. I am changing my tune a bit about exhaust's. I may start looking for something.
#22
Well I think I may have narrowed down my exhaust to either Two Brothers or FMF Q4.
My question is:
Do any owners with either of those pipes on a 2009 or 2010 KLX250SF have issues with (1) pipe heat melting the turn signal and/or (2) pipe heat melting the side fairing next to the pipe?
I've been reading that this does occur but maybe it's a rare thing when it does.
Thanks for any info.
My question is:
Do any owners with either of those pipes on a 2009 or 2010 KLX250SF have issues with (1) pipe heat melting the turn signal and/or (2) pipe heat melting the side fairing next to the pipe?
I've been reading that this does occur but maybe it's a rare thing when it does.
Thanks for any info.
#23
I have an FMF PowerCore4 (which basically the Q4 with a different tip) and have none of the problems you mention.
It was only when I mounted my Edge tail light that I put my number plate holder with side reflectors did I have a small problem. I mounted it too high so it melted off the reflector - hardly a big issue. Indicators are perfectly safe though.
You are worrying about nothing mate - get the slip-on already and be a MUCH happier person!
It was only when I mounted my Edge tail light that I put my number plate holder with side reflectors did I have a small problem. I mounted it too high so it melted off the reflector - hardly a big issue. Indicators are perfectly safe though.
You are worrying about nothing mate - get the slip-on already and be a MUCH happier person!
#24
Then which one (Q4 or Two Brothers)???
Still trying to listen to sound clips...
#25
I also have the Powercore 4 which is just like the Q4 and the rest of the back of the bike is stock and I've had no issues with it, no discoloring of the fender either, it just dosen't happen with a proper install.
#26
Dan
#29
did some mods already!
Removed the stickers. It's faster already with less drag!
Still trying to decide on an exhaust. Probably going to get a Two Brothers -- I like the carbon fiber look to go with the bike.
Still trying to decide on an exhaust. Probably going to get a Two Brothers -- I like the carbon fiber look to go with the bike.