need help fast
#1
need help fast
I am putting in a new jet kit for bike and i dont where to out the needke clip at? I have a q4 fmf and thats it.. im eventually going to a air filter in and thats it.. im putting a 124 main jet in. Please any input is better than none
#3
^beat me to it.
if dynojet, maybe start with the clip in the middle (third notch down from top). and if you have washer spacers, they go on TOP of the clip to help hold it steady in place, not under the clip.
if dynojet, maybe start with the clip in the middle (third notch down from top). and if you have washer spacers, they go on TOP of the clip to help hold it steady in place, not under the clip.
#6
if you purchased the dynojet kit the instructions have suggestions as to what jetting and needle positions to run for altitude, also there is a tech line to call for the manufacturers recommendations. Theres a trouble shooting section also that helps if needed....
#8
At that elevation, you may have a chance of the 128 DJ being on the rich side. Look for the tell-tale signs: excess soot on the exhaust and fender, darker spark plug, and lower fuel mileage. The 128, and even the 124, were rich on my setup at around 2,500 ft and up. But our bikes and setup aren't all the same. Some guys are happily running #132 main jets.