klx250sf air filter and other mods
#11
Universal Short Stalk Turn Signal
#13
You say your filter looks a little dirty so you want to buy a new one? You do realize that these foam filters are meant to be clean many times before needing to be replaced right? Wash in gas, let dry, apply filter oil, let dry, install and run till dirty again.
#14
I realized this today after talking with a guy at work haha. I work on cars so I'm used to just throwing a new filter in. From what I understand the filter setup won't make too much of a difference so I have decided that I will be getting the FMF header and Q4 slip on on top of the jet kit and new tires! Thanks for the pointers, can't wait to get the stuff now haha
#15
My turn signal is slightly melted and blackened after a summer of ridding with the Q4 ... Im debating the competition werkes smoke lens turns signals as an alternative (they do look nice and I wonder if they will actually be out of the way of the exhaust too)... but then I realized the shipping was damn near the price of the signals. I just can't pay near 40 bucks for some turn signals lol.
Universal Short Stalk Turn Signal
Universal Short Stalk Turn Signal
#16
I like those smoked turn signals, I might have to get a couple of sets, for front and rear. Do they come with a connector that just plugs into the normal wiring or do I have to wire them in? I haven't really looked at my lights yet so I'm not sure how they work. Also, I definitively think I'm going to do the rear fender delete with the new signals, what do you guys recommend for a plate bracket? And where is best? I've seen people put them right under the tail light and have seen them mounted sideways on the left under the coolant reservoir, just don't know what the bracket is exactly mounted to.
Comes with the license bracket, light, and signal mounts. Just add signal's and you'll be ready for the rear fender delete.
#17
I believe a lot of peoples the DRC Edge tail light: KLX250 Specials | Electrical | DRC Edge Tail Light(KLX250) - Wheeling Cycle Supply
Comes with the license bracket, light, and signal mounts. Just add signal's and you'll be ready for the rear fender delete.
Comes with the license bracket, light, and signal mounts. Just add signal's and you'll be ready for the rear fender delete.
My concern with the Edge Tail Light would be if I could use incandescent turn signals and get away with not having to wire up the diodes...? I personally am fine with the way the rear fender looks, so I just have a hard time coughing up $80 for the kit plus another $20 or so for some turn signals (I have a lot of other mods comming up that need to be financed)
#18
I like those smoked turn signals, I might have to get a couple of sets, for front and rear. Do they come with a connector that just plugs into the normal wiring or do I have to wire them in? I haven't really looked at my lights yet so I'm not sure how they work. Also, I definitively think I'm going to do the rear fender delete with the new signals, what do you guys recommend for a plate bracket? And where is best? I've seen people put them right under the tail light and have seen them mounted sideways on the left under the coolant reservoir, just don't know what the bracket is exactly mounted to.
#19
I believe a lot of peoples the DRC Edge tail light: KLX250 Specials | Electrical | DRC Edge Tail Light(KLX250) - Wheeling Cycle Supply
Comes with the license bracket, light, and signal mounts. Just add signal's and you'll be ready for the rear fender delete.
Comes with the license bracket, light, and signal mounts. Just add signal's and you'll be ready for the rear fender delete.