KLX250S Lower pegs?
#11
Now Ron, are you bragging that you're able to wheelie through every rut that's over 9" deep?
#12
I say saw the pegs off the mounts to the bike, weld a 1/4" piece of flat stock on the remaining mount portions with however much you want hanging down, weld the outer part onto the 1/4" steel flat stock, grind it up to look good with rounded edges, paint them black, then get a steel shoe for both your left and right boot to act as skid plates should you go riding with TNC - aka "The Toe Buster"!
Thread
Thread Starter
Forum
Replies
Last Post
SDRRider
Ninja ZX-6R & ZX-6RR
7
02-14-2006 08:08 PM