Klx 300 mod advice please
#12
They made KDX200's from 1983 to 2006.so the snorkel was likely the same for all of them. Here's the part number on the bag.
I had wondered WHY was the snorkel so damn large just for a 200...
...until I saw they were 37 horsepower 2 strokes!
I had wondered WHY was the snorkel so damn large just for a 200...
...until I saw they were 37 horsepower 2 strokes!
#16
No. The O2 sensor is attached to the exhaust midpipe near the muffler. It adjusts fuel mixture during partial throttle operation. I did not delete it. The pair valve is on the front of the engine. It injects air into the exhaust for emissions control. I deleted all of the smog equipment. That SmartMoto plate in the picture is on the front of the engine cylinder. That's where the pair valve used to be.
Can u give me a step by step of what you did to delete emissions and for pair valve with part #'s. Thinking I should do the same before power commander install. It all worked out good on your bike? Notice any difference in response or power? Would u recommend?
#17
I did it as part of my bike weight reduction project. Deleting the smog equipment reduced the curb weight from 293 to 291 pounds.
Got it from SmartMoto in Greece. Stuff like this is contraband in the US.
PAIR/AIS Valve Removal kit with Block Off plate PLE-125 - SmartMoto (smartmoto-electronics.com)
Part # PLE-125 $37.50 +shipping
I took off the valve from the front of the engine, installed the block off plate, and plugged in the resister plug to fool the ECU so no trouble lights turn on.
Last edited by tooter; 07-17-2021 at 09:20 PM.
#18
I don't think it makes any performance difference, however it does unclutter the front of the engine.
Gotcha. I might do that further down the line. Thanks for breaking it down for me ,Bro.
I did it as part of my bike weight reduction project. Deleting the smog equipment reduced the curb weight from 293 to 291 pounds.
Got it from SmartMoto in Greece.
PAIR/AIS Valve Removal kit with Block Off plate PLE-125 - SmartMoto (smartmoto-electronics.com)
Part # PLE-125 $37.50 +shipping
Gotcha. I might do that further down the line. Thanks for breaking it down for me ,Bro.
I did it as part of my bike weight reduction project. Deleting the smog equipment reduced the curb weight from 293 to 291 pounds.
Got it from SmartMoto in Greece.
PAIR/AIS Valve Removal kit with Block Off plate PLE-125 - SmartMoto (smartmoto-electronics.com)
Part # PLE-125 $37.50 +shipping
#20