Installing the Duct Inlet 14073-1577
#1
Installing the Duct Inlet 14073-1577
I am pretty new to this, I just bought a new KLX 250 and I am trying to get more HP out of it. I have done some basic mods (IE Two Bros Slip On and Uni air filter), but before taking the bike in to get re-jetted I wanted to make the snorkel mod.
I bought the 14073-1577 duct inlet part off of RonAyers.com but can someone tell me how to install this? Since I plan on taking the bike in to get re-jetted, does anyone have the recommended settings based on these mods? Thanks!
I bought the 14073-1577 duct inlet part off of RonAyers.com but can someone tell me how to install this? Since I plan on taking the bike in to get re-jetted, does anyone have the recommended settings based on these mods? Thanks!
#2
RE: Installing the Duct Inlet 14073-1577
OK, should have looked a little harder, told you I was new at this[8D]
Like they say, picture says a thousands words http://a16tony.smugmug.com/gallery/1134348/1/52832274
Like they say, picture says a thousands words http://a16tony.smugmug.com/gallery/1134348/1/52832274
#3
RE: Installing the Duct Inlet 14073-1577
#5
RE: Installing the Duct Inlet 14073-1577
i like that if i get into water and water goes into the snorkel, it will more likly just drop below the air filter instead of gettin sucked in as its going down.... at least thats what i think..... do you still have your air box lid on?
Thread
Thread Starter
Forum
Replies
Last Post