Could use some advice
#11
I think I discovered your problem!
Seriously, go back to square one, figure out if it is getting gas.
If it is it probably is the slide, but what do I know?
Seriously, go back to square one, figure out if it is getting gas.
If it is it probably is the slide, but what do I know?
Last edited by durielk; 03-10-2017 at 02:13 AM.
#12
Carb issue
Hey durielk, Thanks for the reply Took it all apart again cleaned everything ,slide looks and feels good,very clean inside and all jets are clean. Button it up check fuel from tank good ,Open overflow fuel flow is Good .Check float height Good ,Check spark Good , won't start now . So Is there an electrical issue issue that I would be getting good spark but somehow won't let it fire ? I know just enough to get myself in trouble I misspoke last post . I thought the needle and seat were sold as a package ,seems like the seat doesn't come out .Anyway I'm dead in the water ..
#13
Try a new or different plug, I have had new ones and old ones that look good, but never fire. It looks like you covered all the bases I know of. Maybe time to call in the experts, and don't put yamaha jets in your kawa! That is just crazy!
#15
Funny you should ask I did just get a new IMS tank but I didn't install it yet wanted to get this issue worked out .Anyway I went back out tonight and took it apart again everything looked good buttoned it up and it starts! Take it for a ride it runs fine ,What the heck whatever I did I don't know , must have been operator error ,Long term I don't know yet it's done this several times now runs fine then just dies We'll see
#17
That's a good idea ...I did a little of that yesterday everything under the seat got moved around checked all fuses etc ..I wont know till it does or doesn't do it again ...
#19
Thanks for the reply, No it's not
#20
I went for a 20 mile ride yesterday close to home it ran fine time will tell..Just can't trust it yet
Last edited by donA; 03-13-2017 at 04:25 AM.