Clutch slipping
#11
With the cvk carb I had a 40 pilot jet, fuel mixture screw was out 1-1 1/4 turns out, dj 2206 needle clip in the middle 3rd or 4 th groove from the top, slide drilled as per the instructions, largest main jet provided in that kit. No airbox lid, uni filter, fmf powerbomb header/two bros exhaust w quiet insert. All the free mods were done. Smog equipment removed n sealed off. I’m at sea level.
Higher elevations may require smaller 38 or stock 35 pilot jet depending on your area.
Higher elevations may require smaller 38 or stock 35 pilot jet depending on your area.
#13
The clutch pull is a bit harder, but not really a problem. It took a bit to get used to as it grabs hard with the new plates and springs not as gradual. I stalled it a few times turning at low speeds, I just have to get used to more throttle when starting up.
Thread
Thread Starter
Forum
Replies
Last Post