Carb Jetting 351
#12
Dynojet sizes?
Where do you have your needle clip at? Dynojet kit recommends 4th notch down from the top with two washers on top.
Where do you have your needle clip at? Dynojet kit recommends 4th notch down from the top with two washers on top.
#13
needle raising
OK, got the top of the carb off, what I thought was going to be a screwed on carrier is riveted. Do I have to pull the throttle shaft to raise the arm up & pull the needle out?
#14
Test
OK, decided not to mess with the needle, if it is running why bother....
I got it up to 7000 ft, it even started to burble on the downhills with the throttle closed. Started in the cold perfect. I think we are there good to go... until CO next year, that will be the real test.
Got to get caught up on the other issues.... rebend the skid plate out from the water pump (I guess that was a good $80 item), rework the GPS mount, & try and figure out where I can put my riding/tool kit on this thing (my rear pack on the rack is hitting me on the woops).
I got it up to 7000 ft, it even started to burble on the downhills with the throttle closed. Started in the cold perfect. I think we are there good to go... until CO next year, that will be the real test.
Got to get caught up on the other issues.... rebend the skid plate out from the water pump (I guess that was a good $80 item), rework the GPS mount, & try and figure out where I can put my riding/tool kit on this thing (my rear pack on the rack is hitting me on the woops).
Thread
Thread Starter
Forum
Replies
Last Post