351 testing waters.
#51
I'm seriously looking at the 351 kit for my Australian 2007 KLX 250, does Bill ship to Aus?
I was also looking at getting his Braided brake lines and then thinking about putting on the bigger disc brakes from the 2009 models...
I was also looking at getting his Braided brake lines and then thinking about putting on the bigger disc brakes from the 2009 models...
#54
I was on the phone with Bill earlier this week and he happened to mention the shipping cost to Aus has gone up recently. He defniitely does though, if you are prepared to pay the shipping.
#55
I tried calling the number on the website and asked for Bill and they told me I had the wrong number...
Anyone have his email address so I can send him an email and then follow up with a phone call?
Anyone have his email address so I can send him an email and then follow up with a phone call?
#56
#57
I had my big bore out in imperial valley west of el centro in 105 degrees with no problems other than operator meltdown. Radiator fan would come on only in slow soft areas, once in the fast sand washes it wasn't any problem...
I installed a high pressure radiator cap, Barnett clutch springs, ground out the weld bead in the header flange for better flow, drilled holes in my skid plate, no engine ice just prestone anti freeze & distilled water.
Go for the one your comfortable with 330 or 350. Stock wouldn't outrun an air cooled 84 xl250r I had one....
I installed a high pressure radiator cap, Barnett clutch springs, ground out the weld bead in the header flange for better flow, drilled holes in my skid plate, no engine ice just prestone anti freeze & distilled water.
Go for the one your comfortable with 330 or 350. Stock wouldn't outrun an air cooled 84 xl250r I had one....
He replaced them with EBC springs and has had no problem since.
#58
Careful, careful, careful with those Barnett springs. A former member of this board installed them and started finding pieces of them in his oil. Further inspection revealed most of the Barnett springs had failed, or were on the verge.
He replaced them with EBC springs and has had no problem since.
He replaced them with EBC springs and has had no problem since.
Do you remember where that post was? I recall members complaining about the EBC springs and recommended Barnett instead.
#59
If anyone has his email, I'll send him an email as well..
#60
Last edited by Sharan; 02-28-2013 at 08:50 PM.