Heres it just a few pics i took during my 331 kit install, much thanks to Bill Blue who did a great job. The install went pretty smooth except for having to make numerous trips to the store pick up little things here and there, and the need at times for a third hand but all in all went real nice. I was a little weary about tearing into this project as I have never worked on a bike before this. Although I am very mechanically inclined and have overhauled a few aircraft piston engines. Some of you might think I'm crazy for ripping into such a new bike but I have a long winter here and not much to do on my off time. Besides my warranty will be up by the time riding season kicks back in. I think the power gain will justify my decision as I haven't even taken it for a spin yet. To damn cold, but she did fire right up and sounded very nice and throaty. For now I just have the stock carb installed with 128 main and stock pilot Airbox Lid on, KDX snorkel and K&N. This is just till I have broken the engine in as I know the carb is tuned correctly to my setup. Once this is done I will install the mikuni TM36-68 for the extra giddy up.

 

some more pics

 

Nice job I'm tearing mine down right now for some big things to come...............!

 

You should have put it at tdc when you tore it down.

 

again

 

I did, how do you think i didn't

 

Picks you posted aren't right cams are 180 off

 

I noticed that compared to nobrakes pics of his install but i lined it up with the T on the rotor.

 

Go check again there 2 marks f and t your on f

 

Also to keep in mind due to increase in V/E you Will actually run richer not leaner.