overheating engine = clutch slipping?
#1
overheating engine = clutch slipping?
I know there are a few clutch threads on this forum, but my problem seems a little unique. I just replaced the clutch (barnett frictions and steels) and i am having the same problem I was before. Let me know what you think:
The bike, '86 zx1000r, runs just fine when it starts and the clutch does not slip. when the bike heats up, very warn days and idling in traffic, the clutch starts to slip. I think my thermostat is sticking, so the bike might actually be overheating . . . could this excessive engine heat cause the clutch to slip? The old clutch did not look that worn.
The bike, '86 zx1000r, runs just fine when it starts and the clutch does not slip. when the bike heats up, very warn days and idling in traffic, the clutch starts to slip. I think my thermostat is sticking, so the bike might actually be overheating . . . could this excessive engine heat cause the clutch to slip? The old clutch did not look that worn.
#6
barnett clutches are junk, i put a set in my gixxer once and took it the track & they burnt out on the 3rd pass, ive had really good luck with ebc fibers & oem steels with ebc hd springs in my 636, i would pull the clutch plates out & see if they are worn & go over everything & see if you installed them correctly
#8
Just wondering, did you soak your (fiber) plates in oil for a few minutes before you slapped them together? I've always been a little superstitous; let mine soak in oil for about 10-30 minutes to make sure they are all equally saturated. Call me names; it always works for me.
What kind of oil are you using? (OMG, I'm not trying to ignite the oil-brand thread.)
What kind of oil are you using? (OMG, I'm not trying to ignite the oil-brand thread.)
#9
No, i didn't soak the plates, but since they worked at first this doesn't seem like a likely culprit. I hope that is not it anyway. Honda synthetic blend because it was there. I'll go cheaper next time.
I talked to a local mechanic and he suggested that I drain the clutch line fluid because it is really (possibly the original) old. He said this could be heating up and gumming up and not letting the pressure plate come in full contact. I think I will try this.
I know this makes it sound like I'm really neglectful about maintenance and possibly an idiot, but I'm really neither (most of the time). Thank you all for the advice. keep it coming if you have more.
I talked to a local mechanic and he suggested that I drain the clutch line fluid because it is really (possibly the original) old. He said this could be heating up and gumming up and not letting the pressure plate come in full contact. I think I will try this.
I know this makes it sound like I'm really neglectful about maintenance and possibly an idiot, but I'm really neither (most of the time). Thank you all for the advice. keep it coming if you have more.