General Tech Good at troubleshooting? Have a non specific issue? Discuss general tech topics here.

My 636 RPM hangs up at 8-11K Any Ideas?

Thread Tools
 
Search this Thread
 
  #1  
Old 12-05-2010 | 04:05 PM
ZX14drew's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2010
Posts: 3
Default My 636 RPM hangs up at 8-11K Any Ideas?

Any ideas to start the search?

My 2005 636 has been a solid racer, but at saturdays practice at homestead, the RPM would "hang up" at 8-11K out of corners, it would "pause" there, bike kinda bucking not unlike that momentary fuel starvation feeling, and then it would resume RPM climb to redline. I would upshift and would experience the same 8-10/11K RPM lag or choke point, followed a second later by resumption of power/use of power band.

Stock motor. Any ideas? Thanks!

Drew
Ft lauderdale FL
 
  #2  
Old 12-06-2010 | 09:12 PM
Dragone#19's Avatar
Administrator
Joined: Nov 2005
Posts: 18,288
From: The Silver State
1st Gear Member
Default

was it sitting? as if did this happen after your first tune for the summer?
 
  #3  
Old 12-07-2010 | 08:50 AM
ZX14drew's Avatar
Thread Starter
|
Junior Member
Joined: Dec 2010
Posts: 3
Default

It had not been run on a track for almost 2 months as we installed new equipment (shock, etc.)...This RPM hang up did not occur on the first 3 laps or so, seemed to show up only after it was wrung out / heated up....?
 
  #4  
Old 12-07-2010 | 09:51 PM
768 Ryda's Avatar
Senior Member
1st Gear Member
Joined: Jul 2007
Posts: 748
From: Scottsboro,AL
Default

sounds like a fuel issue, might be a bad fuel pump gettin ready to go out.
 
  #5  
Old 11-20-2015 | 05:17 PM
Silver_ZX636R's Avatar
Junior Member
Joined: Nov 2015
Posts: 2
Default

I am having the same issues with my 04 zx636r. I have tried tuning with a PC3 and also replaced the ECU however no luck.
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
ZX14drew
Ninja ZX-6R & ZX-6RR
2
12-29-2010 07:17 PM
rkelley548
General Tech
6
06-17-2009 07:43 PM
ZX12Rider
Off Topic
50
11-15-2005 01:06 AM
Phase3
General Tech
7
11-11-2005 08:18 AM



Quick Reply: My 636 RPM hangs up at 8-11K Any Ideas?



All times are GMT. The time now is 08:26 AM.